![]() This usually indicates a motherboard problem. Disconnect all Thunderbolt devices and repeat the test. Most likely on a laptop if not, repeat the test with another trackpad if you can. Most likely on a laptop if not, repeat the test with a different keyboard. Disconnect all external devices except those listed above and repeat the test. If the codes are CNW007 or CNW008, ensure your Mac is in range of an active WiFi network, then repeat the test. ADP000 – no issues found, although more advanced diagnostics could still detect a hardware problem.Apple provides a detailed breakdown of the significance and meaning of error codes here. ![]() If testing returns an error, you should be offered further information about support options, which normally proceed after your Mac automatically restarts into Recovery mode. This will enter remote diagnostics, which is usually much slower. If you cannot get the diagnostics to run properly, ensure that your Mac has an internet connection through its Ethernet port, and try again, holding the Option and D keys down. You can also display the results of the last test run in System Information: opne About This Mac, click on the System Report… button, and select the Diagnostics item in the Hardware section, as shown above. If the results from that are unintelligible, try Which should give the result at the end in an XML field of the formĪht-results _namespdiags_aht_valuespdiags_last_run_keyspdiags_version_key1.0.18spdiags_reference_code_keyADP000 Provided that you have not reset the NVRAM, you can later retrieve the last diagnostics result from the NVRAM of recent Mac models using the Terminal command ![]() But a clean bill of health is a good indicator that, whatever is causing your problems, it is unlikely to be a hardware fault in your Mac. Some faults are intermittent, others only manifest when your Mac is warm or cold, and a few (some graphics card faults, in particular) simply don’t get picked up. If the tests report that hardware appears to be functioning correctly, with a zero code or ADP000, this does not prove absolutely that your Mac does not have a hardware fault. A summary of their meanings is given below. Make a note of that, as it will help Apple Support, the Genius Bar, or an authorised engineer to advise you on repair. Once testing has been completed, the app will display a message containing the result, with a code. You may then be invited to choose a language, and tests will either run automatically, or you may be offered a choice of standard or extended testing. Initially, the diagnostics software checks your hardware configuration, to determine what tests it should run. If you need to disconnect peripherals, that is in any case wiser. You should also be able to enter diagnostics from a restart, but Apple recommends shutting down rather than restarting.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |